iHybrid™ is a Packaged Heat Pump and Gas Furnace Unit 80*
AFUE/8.0* HSPF/14 SEER with ECM variable speed
technology for more efficient, quiet furnace (gas) and
heat pump (electric) operation

Scroll compressor—fewer working parts than reciprocating piston compressors for quieter operation, longer service life and reliability

Plastic-coated coil guard and mesh hail guard protect against impact of flying debris due to mowing, golf balls, hail and other hazards

Construction—galvanized steel for added strength and durability, featuring silicone-protected 1.5 mil polyester urethane finish that provides superior corrosion resistance, 50% better protection than standard outdoor finishes

Copper tube/aluminum fin coil design maximizes ratio of heat transfer to inner surface area for more efficient, reliable operation

• GE ECM™ variable-speed motor with built-in speed and torque controls adjust to meet airflow requirements more efficiently and quietly
• Consumes just 60-80 watts compared to 400 watts for a conventional blower motor at constant “FAN” thermostat setting (low speed)
• Maintains airflow capacity automatically compensating for reduced duct volume, dirty air filters, zoning changes, obstructed supply register, etc.

GE ECM™ variable-speed motor can save $150/yr. on cooling plus another $240 in electrical costs for
continuous fan operation

Compared to conventional blower motor based on average savings calculations at 8c/kwh. Actual savings may vary according to utility rates, climate, ductwork, insulation, duty cycle, and lifestyle usage patterns

*3-5 TONS Only
iHybrid is a trademark of NORDYNE.

	iHybrid™ Packaged System
	14 SEER - 4 Stage Heating
	- 2 Stage Cooling

 Multi-Stage, Variable-Speed Technology. The Total Package.

Unlike split systems, where heating and cooling units are separated indoors and out, packaged units perform both functions in a "single package." Depending on structural limitations and available space, packaged systems can be installed on the roof, at ground level, or in the attic. Still, all packaged systems are not alike.

 A packaged heating and cooling system with variable-speed blower provides extra efficiency, reliability and comfort. Four-Stage Heating and Two-Stage Cooling feature operates at lower capacity during mild days, then full capacity during harsher days. Because they idle down to a reduced capacity the NuTone iHybrid package systems provide better comfort and perform quieter than a standard packaged system. Longer cycles improve air circulation, minimizing temperature swings to a couple of degrees, while reducing hot and cold spots.

 Employing patented GE ECMTM variable-speed technology, the blower delivers constant air flow thanks to a programmable electronic controller. It adjusts in real time to meet capacity automatically compensating for reduced duct volume, dirty air filters, zoning changes, obstructed supply register, etc. So the entire system functions more efficiently for more-even temperatures, better indoor air quality, precise humidity control and reduced energy consumption.