Pentek ST-BC-4 Stainless Steel Water Filter Housing
Pentek ST-BC-4 Stainless Steel Water Filter Housing is ideal for schools, restaurants, farms, institutions and industrial use. It offers a variety of solutions for your large-scale, heavy-duty filtration needs. The water filter housing is constructed using 304 stainless steel with a gray-silver epoxy finish. Drains on both the “clean” and “dirty” sides of the sump are included. The Pentek ST-BC-4 water filter housing uses 10 inch standard double open end (DOE) water filter cartridges. It holds four 10" x 2.5" double open end cartridges.
The Pentek ST-BC-4 water filter housing will not accept model GAC, CC, CGAC, TSGAC, WS, PCF or PCC series cartridges. Maximum cartridge diameter is 3" (76 mm). Filter cartridge life depends on the water filter cartridge purchased. The Pentek 143218 is the replacement o-ring for the Pentek ST-BC-4 housing. One o-ring is included with the ST-BC-4 housing. The o-rings should be replaced periodically to maintain a good seal. It is the replacement belly clamp for the Pentek ST-BC-4 housing. One belly clamp is included with the ST-BC-4 housing and only needs to be replaced if it breaks.
Other names of the device are American Plumber, Ametek, Pentek, USFilter 156025, 156025-02, 15602502 Stainless Steel Housing, American Plumber ST-BC-4 Stainless Steel Housing, Ametek ST-BC-4 Stainless Steel Housing and US Filter ST-BC-4 Stainless Steel Housing. If pressure exceeds 125 psi (8.62 bar) at any time, a pressure regulator must be used. Do not use water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Protect against freezing to prevent cracking of the filter and water leakage.
The device is not recommended for applications with TDS or chlorides >1000 ppm and/or pH <5.0. Use of this product in these conditions will void the limited warranty. Consult factory for product modifications for these conditions.