Pentek ST-3 Stainless Steel Water Filter Housing
The Pentek ST-3 Stainless Steel Water Filter Housing is ideal for commercial use, farms, restaurants, spas, and many other applications. It reduces dirt, sand, silt, sediment, rust particles, and scale particles. It effectively provides heavy duty filtration for smaller filtration systems and point-of-use applications. The Pentek ST-3 housings are easy to install and maintain. They are compatible with a complete range of filter cartridges, adding to their versatility. Supplying flow rates of up to 20 gpm (76 L/min), at a maximum water temperature of 300°F (149°C), the Pentek ST3 Stainless Steel Commercial housing is ideal for hot water and high pressure applications not suited for plastic housings. The brushed 304 stainless steel sumps are available with either a pipe plug or pet-cock in the bottom for draining.
The housings are shipped with the drain plug installed. The pet-cock is packaged loose in the carton. The Pentek ST-3 water filter housing heads are manufactured from nickel-plated cast-brass. Protect the Pentek ST-3 housing against freezing to prevent cracking of the filter and water leakage. For drinking water applications, do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. It is not recommended for applications with TDS or chlorides >1000 ppm and/or pH <5.0.
Use of this product in these conditions will void the limited warranty. Product modifications are available for these conditions. The housings should be protected against excessive line hammer. If you are planning to mount the Pentek ST-3 housing, you will need the Pentek 156037 Mounting Bracket with Screws. It is the replacement o-ring for the Pentek ST-3 housing. One o-ring is included with the ST-3 housing. The o-rings should be replaced every two to three filter changes. The Pentek 143220 is the replacement head nut kit for the Pentek ST-3 housing. One head nut kit is included with the ST-3 housing and only needs to be replaced if it breaks. It is the replacement head nut gasket for the Pentek ST-3 housing. One head nut gasket is included with the ST-3 housing.
The Pentek ST-3 housing accepts a complete range of 30 inch standard double open end (DOE) water filter cartridges. The water filter cartridge life depends on the water filter cartridge purchased. American Plumber, Ametek, Pentek, USFilter 156019, 156019-02, 15601902 Stainless Steel Housing; American Plumber ST-3 Stainless Steel Housing; Ametek ST-3 Stainless Steel Housing and US Filter ST-3 Stainless Steel Housing are other names of the device.
Pentek ST-3 Stainless Steel Commercial Housing:
Pentek ST-3 Stainless Steel Housing Specs: